Jump to content

Are Sailor pens overpriced?


arcfide

Recommended Posts

 

Just now, inkstainedruth said:

Does that mean I could swap the nibs on the two 1911S pens?  That would be cool -- because when they came I found I liked the look of the Wicked Witch pen better than that of the Loch Ness Monster -- but like the MF nib on the Loch Ness way better than the super-wet music nib on the Wicked Witch pen.

Ruth Morrisson aka inkstainedruth

 

 

as long as they're the same size.  You may have to heat up the whole nib section in some hot water to soften the glue they use.  https://newtonpens.com/sections-for-the-kop/


We Give Away Scholarships! - Support High School Students Going to College

Link to comment
Share on other sites

  • Replies 31
  • Created
  • Last Reply

Top Posters In This Topic

  • Newton Pens

    5

  • A Smug Dill

    4

  • Uncial

    3

  • arcfide

    3

6 minutes ago, inkstainedruth said:

Does that mean I could swap the nibs on the two 1911S pens?

 

The nibs and feeds are friction-fit and can be just pulled out (if you're prepared to take the risk of damaging them).

I endeavour to be frank and truthful in what I write, show or otherwise present, when I relate my first-hand experiences that are not independently verifiable; and link to third-party content where I can, when I make a claim or refute a statement of fact in a thread. If there is something you can verify for yourself, I entreat you to do so, and judge for yourself what is right, correct, and valid. I may be wrong, and my position or say-so is no more authoritative and carries no more weight than anyone else's here.

Link to comment
Share on other sites

12 hours ago, A Smug Dill said:

 

The nibs and feeds are friction-fit and can be just pulled out (if you're prepared to take the risk of damaging them).

and

https://newtonpens.com/sections-for-the-kop/

 

they're all threaded too.  Once you get past the glue it's nice to be able to just unscrew them.


We Give Away Scholarships! - Support High School Students Going to College

Link to comment
Share on other sites

15 minutes ago, Newton Pens said:

they're all threaded too.

 

Thanks. I've disassembled the gripping section of my Sailor Proske before; so I'm assuming Ruth's “1911S” pens are constructed in the same way. However, I think it's easier for the ‘beginner’ or less fussy user to just pull out the nib and feed, instead of worry about the unknown/variable condition of the glue in the particular pen, even if the simplicity of the procedure is accompanied by risk. (Yes, I've pulled the nibs and feeds out of my gold-nibbed Sailor pens, too, so I'm not just shooting my mouth off and leading others up the garden path.)

 

When the question is whether someone can do something, answering in the positive from a position of experience is empowering and a clear statement of possibility, but not necessarily of what is prudent, or implicitly placing the asker's best interests at heart. Fair warning of possible damage was given.

 

Nagasawa Stationery Center shop-exclusive transparent ‘Skeleton’ demonstrator model of the Sailor Profit Standard.

I endeavour to be frank and truthful in what I write, show or otherwise present, when I relate my first-hand experiences that are not independently verifiable; and link to third-party content where I can, when I make a claim or refute a statement of fact in a thread. If there is something you can verify for yourself, I entreat you to do so, and judge for yourself what is right, correct, and valid. I may be wrong, and my position or say-so is no more authoritative and carries no more weight than anyone else's here.

Link to comment
Share on other sites

8 hours ago, Newton Pens said:

and

https://newtonpens.com/sections-for-the-kop/

 

they're all threaded too.  Once you get past the glue it's nice to be able to just unscrew them.

 

Have you tried  removing the nib from the nib unit after you remove the section.  In the 1911L, you can simply pull the nib and feed out with moderate pull. For the KOP, I am finding it very hard to pull the nib out. What is the best way to do it in your experience for the KOP ?

Link to comment
Share on other sites

43 minutes ago, salmasry said:

 

Have you tried  removing the nib from the nib unit after you remove the section.  In the 1911L, you can simply pull the nib and feed out with moderate pull. For the KOP, I am finding it very hard to pull the nib out. What is the best way to do it in your experience for the KOP ?

 

the way in the link, with heating up the section in hot water, is the best way.  for me.


We Give Away Scholarships! - Support High School Students Going to College

Link to comment
Share on other sites

12 minutes ago, Newton Pens said:

 

the way in the link, with heating up the section in hot water, is the best way.  for me.

Thanks for the reply, 

 

I like this idea alot.  It is much better than whatever I came up with :)

 

I was just making sure  that it will be able to remove the nib and feed from the nib unit.  The link is specific about just removing the section to change it to another section, and I was not sure that the method would work for removing the nib as well.

 

 

Link to comment
Share on other sites

22 hours ago, Newton Pens said:

 

 

 

as long as they're the same size.  You may have to heat up the whole nib section in some hot water to soften the glue they use.  https://newtonpens.com/sections-for-the-kop/

Well, they're both 1911S pens, so I'm presuming they're the same.  If they unscrew, I could just swap the entire nib and feed the way I would on a Pelikan M200/M400 nib unit, or a vintage Esterbrook one.

Ruth Morrisson aka inkstainedruth 

"It's very nice, but frankly, when I signed that list for a P-51, what I had in mind was a fountain pen."

Link to comment
Share on other sites

Not to me, even though quite a few of the special editions are beyond my maximum budget.

"The trouble with the world is that the stupid are cocksure and the intelligent are full of doubt."

 

B. Russell

Link to comment
Share on other sites

15 hours ago, salmasry said:

Thanks for the reply, 

 

I like this idea alot.  It is much better than whatever I came up with :)

 

I was just making sure  that it will be able to remove the nib and feed from the nib unit.  The link is specific about just removing the section to change it to another section, and I was not sure that the method would work for removing the nib as well.

 

 

oh yeah you can just pull the nib and feed from the whole section.  I like to use a bit of soft rubber from a bicycle tube as a grippy grabber.


We Give Away Scholarships! - Support High School Students Going to College

Link to comment
Share on other sites

My Sailor 1911L in a broad nib feels like writing with a felt tipped pen, only with much less friction. I quite enjoy it, and don't think it's overpriced. It's just not for everyone.

Link to comment
Share on other sites

I don’t know how anyone can say Sailor pens are overpriced. For people who like Sailor nibs there is really nothing else at any price that can offer the same writing experience. That has to be worth a premium.

 

Even if you don’t find Sailor nibs exceptional then at least you have to concede that many others do and will happily pay more for a Sailor than a comparable pen with a different nib.


I think Sailor is one of the few pen companies that make something truly special.

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Most Contributions

  • Upcoming Events

  • Blog Comments

    • Misfit
      Oh to have that translucent pink Prera! @migo984 has the Oeste series named after birds. There is a pink one, so I’m assuming Este is the same pen as Oeste.    Excellent haul. I have some Uniball One P pens. Do you like to use them? I like them enough, but don’t use them too much yet.    Do you or your wife use Travelers Notebooks? Seeing you were at Kyoto, I thought of them as there is a store there. 
    • A Smug Dill
      It's not nearly so thick that I feel it comprises my fine-grained control, the way I feel about the Cross Peerless 125 or some of the high-end TACCIA Urushi pens with cigar-shaped bodies and 18K gold nibs. Why would you expect me or anyone else to make explicit mention of it, if it isn't a travesty or such a disappointment that an owner of the pen would want to bring it to the attention of his/her peers so that they could “learn from his/her mistake” without paying the price?
    • szlovak
      Why nobody says that the section of Tuzu besides triangular shape is quite thick. Honestly it’s the thickest one among my many pens, other thick I own is Noodler’s Ahab. Because of that fat section I feel more control and my handwriting has improved. I can’t say it’s comfortable or uncomfortable, but needs a moment to accommodate. It’s funny because my school years are long over. Besides this pen had horrible F nib. Tines were perfectly aligned but it was so scratchy on left stroke that collecte
    • stylographile
      Awesome! I'm in the process of preparing my bag for our pen meet this weekend and I literally have none of the items you mention!! I'll see if I can find one or two!
    • inkstainedruth
      @asota -- Yeah, I think I have a few rolls in my fridge that are probably 20-30 years old at this point (don't remember now if they are B&W or color film) and don't even really know where to get the film processed, once the drive through kiosks went away....  I just did a quick Google search and (in theory) there was a place the next town over from me -- but got a 404 error message when I tried to click on the link....  Ruth Morrisson aka inkstainedruth 
  • Chatbox

    You don't have permission to chat.
    Load More
  • Files






×
×
  • Create New...