Jump to content

Esterbrook 2284 (Italic?) Nib Tuning?


corgicoupe

Recommended Posts

I acquired a 2284 nib (stub or italic?) at the Atlanta pen show yesterday. The price was excellent ($0.00) because the tines were out of alignment and the gentleman behind the table was gracious. I got the tines back into alignment, but I see two remaining problems. First, one seems to be longer than the other by a fraction of a mm, which makes it scratchy, and the tines are separated at the end.

 

My question is whether I should deal with the spacing first, or get the tines equal in length first? What is the best way to close up the tines? After those two issues are resolved, should I attempt to round over the edges, or leave them sharp? TIA

Edited by corgicoupe

Baptiste knew how to make a short job long

For love of it. And yet not waste time either.

Robert Frost

Link to comment
Share on other sites

  • Replies 9
  • Created
  • Last Reply

Top Posters In This Topic

  • corgicoupe

    4

  • pajaro

    3

  • jabberwock11

    2

  • Piper 987

    1

Top Posters In This Topic

This is a stub. I have a couple of these, and the tines are not sharp. Even the 2312 italic is more cursive italic and not very sharp. My 2284s stubs are pretty smooth. If one tine is shorter than the other I would wonder if the very tip were missing on one.

"Don't hurry, don't worry. It's better to be late at the Golden Gate than to arrive in Hell on time."
--Sign in a bar and grill, Ormond Beach, Florida, 1960.

 

 

Link to comment
Share on other sites

I just looked again. Interestingly, the tines appear to be the same length when viewed from the top surface, but when viewed from the feed side one is a fraction of a mm shorter. I surmise that this could have happened if someone attempted to smooth the nib when the tines were misaligned. Particularly if they only ground the bottom surface.

 

If that is so, then I can fix that, but I still have the question about bringing the point of the nib closer together. Aren't they supposed to be just touching?

Baptiste knew how to make a short job long

For love of it. And yet not waste time either.

Robert Frost

Link to comment
Share on other sites

Most of Esterbrook's "stub" nibs are actually oblique nibs, that includes your 2284. It's not damaged or worn down, it was designed that way. Obliques take some getting used to, and must be held precisely for them to write properly. To be honest I never much cared for them.

If you're looking for a good actual stub nib for your Esterbrook, try a Venus medium. It's not technically a stub, but it has line variation and writes the exact same way as a fine stub nib (similar to a 0.6 or 0.8).

 

 

Here's a quick example of the line variation from a Venus medium:

 

http://40.media.tumblr.com/9e3fd2d475d2640454f7d266994798fe/tumblr_o5v4jcygbj1uf00n4o1_1280.jpg

Edited by jabberwock11
Link to comment
Share on other sites

Most of Esterbrook's "stub" nibs are actually oblique nibs, that includes your 2284. It's not damaged or worn down, it was designed that way. Obliques take some getting used to, and must be held precisely for them to write properly. To be honest I never much cared for them.

 

If you're looking for a good actual stub nib for your Esterbrook, try a Venus medium. It's not technically a stub, but it has line variation and writes the exact same way as a fine stub nib (similar to a 0.6 or 0.8).

The 2284 and 9284 are stubs, but they are not oblique. The obliques would be the 2314 and 9314 in -F, -M and -B. I have all of these.

"Don't hurry, don't worry. It's better to be late at the Golden Gate than to arrive in Hell on time."
--Sign in a bar and grill, Ormond Beach, Florida, 1960.

 

 

Link to comment
Share on other sites

fpn_1461095298__esterbrook_2284_nib_2016

Baptiste knew how to make a short job long

For love of it. And yet not waste time either.

Robert Frost

Link to comment
Share on other sites

The Snyder Chart ( http://www.snyderfamily.com/current/estienibs.htm ) describes the Esterbrook 2284 nib as "Broad Firm Stub - Signature".

 

However, a close look at a NOS 2284 does show it to have a slight left oblique shape. It's subtle but it's there.

 

http://www.andersonpens.com/v/vspfiles/photos/EST-2284-2.jpg

Ink has something in common with both money and manure. It's only useful if it's spread around.

Link to comment
Share on other sites

None of the Esterbrook obliques are called obliques, but they are. It just wasn't a term that Esterbrook really used.

Link to comment
Share on other sites

Agreed.

Baptiste knew how to make a short job long

For love of it. And yet not waste time either.

Robert Frost

Link to comment
Share on other sites

The Snyder Chart ( http://www.snyderfamily.com/current/estienibs.htm ) describes the Esterbrook 2284 nib as "Broad Firm Stub - Signature".

 

However, a close look at a NOS 2284 does show it to have a slight left oblique shape. It's subtle but it's there.

 

http://www.andersonpens.com/v/vspfiles/photos/EST-2284-2.jpg

 

This is so thin it's almost invisible. The Relief nibs are the obliques. This is a stub. What is there is that these nibs sometimes have one tine very slightly shorter than the other. These were not expensive nibs. Read the write ups on esterbrook.net for some clarification. What is in the picture is a straight across stub. When you see a Relief nib or someone else's oblique nib, the slant is clear.

 

None of the Esterbrook obliques are called obliques, but they are. It just wasn't a term that Esterbrook really used.

 

You are right. The obliques are called Relief nibs.

"Don't hurry, don't worry. It's better to be late at the Golden Gate than to arrive in Hell on time."
--Sign in a bar and grill, Ormond Beach, Florida, 1960.

 

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now







×
×
  • Create New...