Search the Community
Showing results for tags 'hairdryer'.
Discovered a small screw on the plastic shroud, and one thing led to another. Was reading the excelent thread pinned in Esterbrook on resacing and remembered this rig I built. The key was cuting 4 slots in the 1½" piece of copper pipe and mushrooming it over the tapered end of the beast. I stopped at 2 screws to secure it. A 'T' and some caps, and a few short lengths of pipe were lightly sweated together. The remaining open part of the tee forms a nice friction fit that allows ajustment to any angle. Hardest part is calculating the size the slit needs to be. The formula is simple enough, but much easier in mm's. It works like a Swiss lawnmower (I hope those are good.) same amount of heated air, just directed in a nice fan shape for heating just the shallacked section. She stays in the bullpen more nowdays (Digitall Infinitely Adjustable heat gun and others takeing over her duties. I would build one again, sometimes you need that sliver of verry hot air nothing else will deliver. It lives a little further off the desk as shown because it does run hot. The next project comming is a fairly large write-up on whittling Vacumatic pump pellet cups out of Papermate Inksticks. Some times I enjoy making pen tools and accessories, as much as fixing the pens. Dad used to say, if you cant make a part or a specil tool... Hell, whwt makes you think you can fix stuff."