Jump to content

Pelikan M1000 Dripping, What Happened?


fountainpen51

Recommended Posts

Hello, I was writing and ink has begun to form on the tip, if I leave it face down it drips, I do not know what has happened, the ink is Diamine Turquoise, I have used it other times and this has never happened. I have tried to change the position of the nib and it remains the same. I had not used it for a while.
What happened here? Any suggestions?

Thanks

post-139002-0-54128100-1521804743.jpg

Link to comment
Share on other sites

  • Replies 27
  • Created
  • Last Reply

Top Posters In This Topic

  • fountainpen51

    13

  • hari317

    3

  • Bo Bo Olson

    3

  • Needhelp

    2

Top Posters In This Topic

Posted Images

Check that the nib is screwed in fully.

Look for tiny cracks in the barrel - best discovered by running a fingernail lightly over the pen (especially at the join to the grip).

If there is leaking out the back at the piston or the piston feels stiff, it may be the seals of the piston need greasing again.

Sometimes if a nib is sprung from over flexing/forcing the nib the nib will lift permanently away from the feed and ink can flow uninterrupted down the channel.

Other than that, I'm afraid I have no idea.

Link to comment
Share on other sites

Check that the nib is screwed in fully.

Look for tiny cracks in the barrel - best discovered by running a fingernail lightly over the pen (especially at the join to the grip).

If there is leaking out the back at the piston or the piston feels stiff, it may be the seals of the piston need greasing again.

Sometimes if a nib is sprung from over flexing/forcing the nib the nib will lift permanently away from the feed and ink can flow uninterrupted down the channel.

Other than that, I'm afraid I have no idea.

Everything seems to be correct, the pen is relatively new, has been used little and has not been flexed with this nib.
I noticed that when you turn it down, the ink accumulates quickly and when you put it upwards, the ink goes back inside.
He had not used it for a few weeks and he has not received any shock or anything strange.
Link to comment
Share on other sites

I wonder whether the feed is over saturated and just can't modulate ink flow as well? Can you release 5-10 drops of ink and then retract the piston to suck excess ink from the feed?

Link to comment
Share on other sites

I wonder whether the feed is over saturated and just can't modulate ink flow as well? Can you release 5-10 drops of ink and then retract the piston to suck excess ink from the feed?

 

 

The best place to get help is to directly contact Pelikan or the place you bought it from.

 

Keep doing the same thing, keep falling ink, I do not understand what it can be, I have used it for quite some time, it has been with me for about a year and it has been in continuous rotation and this has never happened. I did not buy it directly in a store, a collector friend sold it to me to be brand new.

Link to comment
Share on other sites

Do you have another known good nib unit?

 

If yes, install that on this pen and see. If problem persists, there is an air leak in your pen. If problem is solved then your other nib unit is faulty or badly assembled.

In case you wish to write to me, pls use ONLY email by clicking here. I do not check PMs. Thank you.

Link to comment
Share on other sites

Have you tried a different ink ?

 

 

Do you have another known good nib unit?

 

If yes, install that on this pen and see. If problem persists, there is an air leak in your pen. If problem is solved then your other nib unit is faulty or badly assembled.

Yes, I have tested drier inks, ink does not accumulate on the tip as fast, but it does. I have no other nib at hand to prove it or anyone close to me ...

Link to comment
Share on other sites

ok, I have put an ink sack in the nib, I have loaded it and the ink falls slower, but it continues to do so, so I guess the problem comes from the nib set ... I have changed the position of the nib with the feeder I do not know how many times already ......., so I do not know what else can be done .......

Edited by fountainpen51
Link to comment
Share on other sites

Ink leaks/drips out when more air gets into the pen than should, so the flow through the feed is not properly regulated.

 

A feed that is not set properly against the nib may cause flow issues, but I would not expect it to drip. A nib that is not screwed in properly (it only has to be snug, not tight) may cause an issue. I have had it happen when section threads are not sealed with rosin, but this pen is not made that way, though you could have damage to the front piece of the section, which is by no means uncommon in the larger Pelikans. But I would expect ink to come out the section/barrel joint.

 

Sherlock Holmes said "When all other possibilities have been eliminated, whatever remains, however improbable, must be the answer." What remains is a damaged piston seal, letting ink in at the back end of the pen. Just for yucks, fill the pen, and wrap a tight layer of electrical tape (Scotch 33+ is perfect for this because it stretches and pulls back for a very snug fit) where the grip knob meets the barrel and see what happens. With that sealed off, air can't get in through the back end of the seal. If that doesn't work, send it to someone to repair.

spacer.png
Visit Main Street Pens
A full service pen shop providing professional, thoughtful vintage pen repair...

Please use email, not a PM for repair and pen purchase inquiries.

Link to comment
Share on other sites

Ink leaks/drips out when more air gets into the pen than should, so the flow through the feed is not properly regulated.

 

A feed that is not set properly against the nib may cause flow issues, but I would not expect it to drip. A nib that is not screwed in properly (it only has to be snug, not tight) may cause an issue. I have had it happen when section threads are not sealed with rosin, but this pen is not made that way, though you could have damage to the front piece of the section, which is by no means uncommon in the larger Pelikans. But I would expect ink to come out the section/barrel joint.

 

Sherlock Holmes said "When all other possibilities have been eliminated, whatever remains, however improbable, must be the answer." What remains is a damaged piston seal, letting ink in at the back end of the pen. Just for yucks, fill the pen, and wrap a tight layer of electrical tape (Scotch 33+ is perfect for this because it stretches and pulls back for a very snug fit) where the grip knob meets the barrel and see what happens. With that sealed off, air can't get in through the back end of the seal. If that doesn't work, send it to someone to repair.

Done, it continues to accumulate and drip from the tip...., no ink is seen from the section / barrel.
Any recommendation of whom to send to fix in the not too distant future?
Link to comment
Share on other sites

 

Done, it continues to accumulate and drip from the tip...., no ink is seen from the section / barrel.
Any recommendation of whom to send to fix in the not too distant future?

 

Ron would be an excellent choice

A consumer and purveyor of words.

 

Co-editor and writer for Faith On Every Corner Magazine

Magazine - http://www.faithoneverycorner.com/magazine.html

 

 

Link to comment
Share on other sites

Ron would be an excellent choice

I've read that, but from where I live it is possible that the taxes of return and return are almost as expensive as buying a new nib, although I do not rule it out, but someone perhaps closer in Europe?

Link to comment
Share on other sites

Pelikan service centre at Hannover has been excellent to me over several instances. HTH.

Are prices reasonable or do they tend to be higher?

Link to comment
Share on other sites

Are prices reasonable or do they tend to be higher?

They could not have charged lower than what they charged. Free of cost inclusive of return shipping.

 

I sent the pen off using a tracked mode with a detailed covering letter and my return address clearly mentioned.

In case you wish to write to me, pls use ONLY email by clicking here. I do not check PMs. Thank you.

Link to comment
Share on other sites

Thanks, I'll try to see how.

 

They could not have charged lower than what they charged. Free of cost inclusive of return shipping.

I sent the pen off using a tracked mode with a detailed covering letter and my return address clearly mentioned.

Link to comment
Share on other sites

Don't think it's the nib but the plastic gasket seal.

In reference to P. T. Barnum; to advise for free is foolish, ........busybodies are ill liked by both factions.

 

 

The cheapest lessons are from those who learned expensive lessons. Ignorance is best for learning expensive lessons.

 

 

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Most Contributions

    1. amberleadavis
      amberleadavis
      43844
    2. PAKMAN
      PAKMAN
      33583
    3. Ghost Plane
      Ghost Plane
      28220
    4. inkstainedruth
      inkstainedruth
      26772
    5. jar
      jar
      26105
  • Upcoming Events

  • Blog Comments

    • Shanghai Knife Dude
      I have the Sailor Naginata and some fancy blade nibs coming after 2022 by a number of new workshop from China.  With all my respect, IMHO, they are all (bleep) in doing chinese characters.  Go use a bush, or at least a bush pen. 
    • A Smug Dill
      It is the reason why I'm so keen on the idea of a personal library — of pens, nibs, inks, paper products, etc. — and spent so much money, as well as time and effort, to “build” it for myself (because I can't simply remember everything, especially as I'm getting older fast) and my wife, so that we can “know”; and, instead of just disposing of what displeased us, or even just not good enough to be “given the time of day” against competition from >500 other pens and >500 other inks for our at
    • adamselene
      Agreed.  And I think it’s good to be aware of this early on and think about at the point of buying rather than rationalizing a purchase..
    • A Smug Dill
      Alas, one cannot know “good” without some idea of “bad” against which to contrast; and, as one of my former bosses (back when I was in my twenties) used to say, “on the scale of good to bad…”, it's a spectrum, not a dichotomy. Whereas subjectively acceptable (or tolerable) and unacceptable may well be a dichotomy to someone, and finding whether the threshold or cusp between them lies takes experiencing many degrees of less-than-ideal, especially if the decision is somehow influenced by factors o
    • adamselene
      I got my first real fountain pen on my 60th birthday and many hundreds of pens later I’ve often thought of what I should’ve known in the beginning. I have many pens, the majority of which have some objectionable feature. If they are too delicate, or can’t be posted, or they are too precious to face losing , still they are users, but only in very limited environments..  I have a big disliking for pens that have the cap jump into the air and fly off. I object to Pens that dry out, or leave blobs o
  • Chatbox

    You don't have permission to chat.
    Load More
  • Files






×
×
  • Create New...