Unscrew Nib Montblanc 32

[kdv]

Ls,

 

I know there is a thread about dismantling montblancs in the 20/30 series. But it is not demonstrated how too “take-out” the nib of a mb 32. Should the be pulled towards the front or pushed backwards?

Greetings

kdv

 

[Chrissy]

There's a FPN thread on repairing the Montblanc 32 piston filler. I've never seen one, but the section unscrews for access to the piston, so it's quite likely the nib would come out of the front.

 

Someone else will come along who knows for certain though.

[kdv]

thanks Chrissy,

I'll wait a little longer before repairing

greetings

kdv

[hari317]

Ls,

 

I know there is a thread about dismantling montblancs in the 20/30 series. But it is not demonstrated how too take-out the nib of a mb 32. Should the be pulled towards the front or pushed backwards?

Greetings

kdv

 

Unscrew the section. Then push the nib backwards into the section. It will exit from back of the section. You are asking about the intarsia nib version I hope. Post a pic of your pen.

[kdv]

voila

 

 

[Chrissy]

Ohhhh darn, I should have searched for images of the pen model. I think all of those intarsia nib types go backwards into the section.

 

It's a good job that Hari is here.

[hari317]

Thats the intarsia nib.

[hari317]

Sometimes the nib is a very tight fit. You have to patiently nudge it out to the back. The feeder is a wonderfully machined ebonite item, springy and fragile. Handle it carefully.

 

Dont remove the nib unless it is required.

 

Good luck!

Edited March 18, 2018 by hari317

[siamackz]

I use a rubber grip to gently push back the nib into the section - thumb on feed and forefinger wrapped around the nib. Push the feed part in. As soon as it dislodges then the nib will be freed too.

Edited March 18, 2018 by siamackz