Jump to content

Having Issues With My First Fountain Pen


antoipod

Recommended Posts

Hello membersFPN, this is my first post here. I have been having some issues with my first fountain pen, a Scrikss honor 38. It writes extremely wet for the first few lines but the more I write the dryer it seems to get and becomes nearly unusable because of skipping. It skips even when writing wet but it gets worse the dryer it gets. I noticed that when I suck up only ink into the converter, the pen just dumps ink on the page and writes very wet but writes a decent amount dryer if I suck a bit of air into the converter. I already got a replacement pen, a Pilot Metropolitan, but was wondering if these issues could be easily fixed or were the result of newbie mistakes or if it's just a bad pen. Here are some pictures:

post-139460-0-64170200-1507938732_thumb.jpg

post-139460-0-62844000-1507938761_thumb.jpg

Link to comment
Share on other sites

  • Replies 16
  • Created
  • Last Reply

Top Posters In This Topic

  • antoipod

    5

  • ParkerDuofold

    3

  • Bluey

    2

  • LizEF

    2

Top Posters In This Topic

Posted Images

Hello Antoipod,

 

:W2FPN:

 

It sounds like a classic case of ink starvation... this can be a problem with any cartridge/converter fountain pen. I've experienced it myself a few times.

 

The causes and solutions can be varied; hopefully reading through this thread will reveal the correct solution for you.

 

https://www.fountainpennetwork.com/forum/topic/327043-why-do-pens-run-dry-with-plenty-of-ink-still-in-them/?fromsearch=1

 

That said, it has been my experience that loose fitting converters are the usual culprit... also make sure you give the pen a good flush to make sure all the factory oils and debris are cleaned out. ;)

 

Rots of ruck. :)

 

 

- Anthony

Link to comment
Share on other sites

Just to follow-up, I've also had some luck switching to cartridges, (much to my chagrin). Cartridges can be re-filled from a bottle using an ink syringe... so not all is lost. :D

 

 

- A.C.

Link to comment
Share on other sites

Welcome to our group. There are no bad questions here. Just us learning from each other. So, feel free to jump into any of our conversations. You’re one of us now.

 

No, you didn’t do anything wrong. Actually you did a really smart thing by buying the Pilot Metropolitan.

It’s one of the most popular starter pens. They are great, dependable writers. Even experienced pen users will leave their expensive pens behind, stick a Metropolitan into a pen sleeve and then into a backpack or briefcase.(Nib up)

I would check out BRIAN Goulet’s videos on everyday carry pens on YouTube. Best of luck to you.

Link to comment
Share on other sites

I’ve had a couple of Scriksses (?), and they don’t behave the way you are describing. I agree that a good flush should help a lot. I like the pens.

Link to comment
Share on other sites

 

That said, it has been my experience that loose fitting converters are the usual

I took a look at the converter after reading your reply and noticed that the end of the converter looks very rough and bumpy, like it was roughly cut. I'll try using cartridges.

Link to comment
Share on other sites

Try flushing the pen real well, so that you clean out the residue that might be clogging up your pen. And, go and buy a better quality pen. The Pilot Metropolitan is a good pen, try out the Lamy Safari and Lamy Al-Star pens.

Edited by Wolverine1
Link to comment
Share on other sites

I’ve had a couple of Scriksses (?), and they don’t behave the way you are describing. I agree that a good flush should help a lot. I like the pens.

This.

The OP needs to soak the nib part and converter for a few hours in a mix of dishsoap and water, then flush with water.

 

 

Try flushing the pen real well, so that you clean out the residue that might be clogging up your pen. And, go and buy a better quality pen. The Pilot Metropolitan is a good pen, try out the Lamy Safari and Lamy Al-Star pens.

They're not better "quality".

Edited by Bluey
Link to comment
Share on other sites

I took a look at the converter after reading your reply and noticed that the end of the converter looks very rough and bumpy, like it was roughly cut. I'll try using cartridges.

Hello Antoipod,

 

Okay, good deal... hopefully that'll do it. :thumbup:

 

It sounds to me like you're getting air into the system from that chewed-up converter... from the way the flow comes and goes... if it were dirt in the pen, I do not think that would permit very wet flow one minute and then almost no flow the next... that sounds more like an air induced capillary problem, IMHO.

 

However, just to sate everyone's curiosity... including my own... you did give the pen a good flush when you got it, right?

 

Be well and please keep us posted. :)

 

 

- Anthony

Link to comment
Share on other sites

Hello Antoipod,

Okay, good deal... hopefully that'll do it. :thumbup:

It sounds to me like you're getting air into the system from that chewed-up converter... from the way the flow comes and goes... if it were dirt in the pen, I do not think that would permit very wet flow one minute and then almost no flow the next... that sounds more like an air induced capillary problem, IMHO.

However, just to sate everyone's curiosity... including my own... you did give the pen a good flush when you got it, right?

Be well and please keep us posted. :)

- Anthony

I tried flushing it with some water mixed with dish soak and then soaked it in the solution for 10 minutes then flushed it with clean water, I also ditched the converter and tried using cartridges. It seems like the wetness and dryness issues are gone but it still skips (although not as often as before). It seems like it skips or stops writing between words or after not writing something for 2-3 seconds, when it does I have to flip the nib over and write a little bit like that to get it flowing again. After looking at the nib with a magnifying glass, it looks like the tines are much further appart that my pilot metropolitan and the feed gap seems to get bigger from the breather hole to the nib.
Link to comment
Share on other sites

I tried flushing it with some water mixed with dish soak and then soaked it in the solution for 10 minutes then flushed it with clean water, I also ditched the converter and tried using cartridges. It seems like the wetness and dryness issues are gone but it still skips (although not as often as before). It seems like it skips or stops writing between words or after not writing something for 2-3 seconds, when it does I have to flip the nib over and write a little bit like that to get it flowing again. After looking at the nib with a magnifying glass, it looks like the tines are much further appart that my pilot metropolitan and the feed gap seems to get bigger from the breather hole to the nib.

10 minutes isn't really long enough, so that's probably why it still skips. Try at least 3 hours.

 

Then we'll deal with the tine gap, if necessary. I have a Pilot FA nib that used to skip and I solved that by closing the tines, but we'll see how the above recommendation goes before doing that.

Edited by Bluey
Link to comment
Share on other sites

10 minutes isn't really long enough, so that's probably why it still skips. Try at least 3 hours.

 

Then we'll deal with the tine gap, if necessary. I have a Pilot FA nib that used to skip and I solved that by closing the tines, but we'll see how the above recommendation goes before doing that

I soaked it for 3 hours in water mixed with dish soap but it still skips, just not as much as it used to. It skips maybe 3 times per sentence, which is quite a bit more than my Pilot metropolitan (I seem to have gotten a lemon Metropolitan). How shall I tackle reducing tine gap?

Link to comment
Share on other sites

I soaked it for 3 hours in water mixed with dish soap but it still skips, just not as much as it used to. It skips maybe 3 times per sentence, which is quite a bit more than my Pilot metropolitan (I seem to have gotten a lemon Metropolitan). How shall I tackle reducing tine gap?

 

Here are two videos on the topic:

 

 

 

Not sure, but this video may also address the question:

Link to comment
Share on other sites

 

Here are two videos on the topic:

 

 

 

Not sure, but this video may also address the question:

I realized the nib and feed were removable and followed the videos you recommend, it seems like the skipping issue has been resolved. Thx for the help :D

Link to comment
Share on other sites

I realized the nib and feed were removable and followed the videos you recommend, it seems like the skipping issue has been resolved. Thx for the help :D

 

:) Gladly.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Most Contributions

    1. amberleadavis
      amberleadavis
      43844
    2. PAKMAN
      PAKMAN
      33494
    3. Ghost Plane
      Ghost Plane
      28220
    4. inkstainedruth
      inkstainedruth
      26624
    5. jar
      jar
      26101
  • Upcoming Events

  • Blog Comments

    • Shanghai Knife Dude
      I have the Sailor Naginata and some fancy blade nibs coming after 2022 by a number of new workshop from China.  With all my respect, IMHO, they are all (bleep) in doing chinese characters.  Go use a bush, or at least a bush pen. 
    • A Smug Dill
      It is the reason why I'm so keen on the idea of a personal library — of pens, nibs, inks, paper products, etc. — and spent so much money, as well as time and effort, to “build” it for myself (because I can't simply remember everything, especially as I'm getting older fast) and my wife, so that we can “know”; and, instead of just disposing of what displeased us, or even just not good enough to be “given the time of day” against competition from >500 other pens and >500 other inks for our at
    • adamselene
      Agreed.  And I think it’s good to be aware of this early on and think about at the point of buying rather than rationalizing a purchase..
    • A Smug Dill
      Alas, one cannot know “good” without some idea of “bad” against which to contrast; and, as one of my former bosses (back when I was in my twenties) used to say, “on the scale of good to bad…”, it's a spectrum, not a dichotomy. Whereas subjectively acceptable (or tolerable) and unacceptable may well be a dichotomy to someone, and finding whether the threshold or cusp between them lies takes experiencing many degrees of less-than-ideal, especially if the decision is somehow influenced by factors o
    • adamselene
      I got my first real fountain pen on my 60th birthday and many hundreds of pens later I’ve often thought of what I should’ve known in the beginning. I have many pens, the majority of which have some objectionable feature. If they are too delicate, or can’t be posted, or they are too precious to face losing , still they are users, but only in very limited environments..  I have a big disliking for pens that have the cap jump into the air and fly off. I object to Pens that dry out, or leave blobs o
  • Chatbox

    You don't have permission to chat.
    Load More
  • Files






×
×
  • Create New...