Hi everybody,
Can you help out a newby I need to buy a clip for my De La Rue 1332, any suggestions welcome, but I'm a long way from the USA.
Regards and thanks,
Peeteach

Hi there,
I have a few Onoto and TDR clips, if you can supply a photo and sizes of the one you require, I may be able to help out.

et

Hi, thanks for your interest, a photograph I cant supply as the I dont have the pieces, but I understand that the clip has a sunburst on it. The internal diameter of the bit that was left attached to the cap is not precise (by may standards, ex engineer I'm afraid) and varies between 9 and 9.3mm the external diameter is (on average) 10.83mm. I would estimate the length to be circa 38mm (1.5inch) I know I would expect them to be whole numbers, but they dont make sense in imperial size either!!!! but who knows what happened to it over the years.
If you have anything even approaching this I would be eternally gratefull.
Perhaps you could email me direct on peeteach@gmail.com
Again thanks for your interest I do appreciate it.
Regards
Peeteach