Jump to content

Help! Blobs Of Ink Spewing From My Pilot Penmanship


Oldtimer

Recommended Posts

i am loving my first Pilot Penmanship pen, but the continuous blobs of ink are a nuisance. I am using it as an eyedropper and am wondering if that could be the problem. Although i doubt it. A big drop of ink keeps building up on top of the nib while i write until it slides into the paper. Left overnight capped with nib down i woke up to a drop of ink inside the cap , which had obviously dripped from the nib.

 

Is this a regular thing with these pens or can i do something to fix it? Maybe try it with the converter? I am hoping that my all black pen arriving today is going to be different, because it really writes like wanted a pen to write. FExtra fine and smooth!

Link to comment
Share on other sites

  • Replies 12
  • Created
  • Last Reply

Top Posters In This Topic

  • Oldtimer

    7

  • KBeezie

    4

  • brunico

    1

  • Kevan

    1

If you're using it as an eye-dropper are you making sure to do least one of two things?

 

1) using an o-Ring on the section to keep it airtight

or

2) using silicone grease around the section threads to keep it air tight?

 

If you're not doing either, it may not be air/water tight and air is seeping in and causing the ink to slowly leak and blob out forward and in general being way to wet.

Link to comment
Share on other sites

i am doing the "silicon thing" only. I don't have o-rings right now.

 

So, is it possible i need to do both?

 

if that is the case if i use the converter i should not experience the blobs… i mean, the cartridge.

Edited by Oldtimer
Link to comment
Share on other sites

Problem solved by using a cartridge…Then it writes a little dryer but OK. Thanks

It's likely that even with the silicone grease there was still getting in (my pilot petit1 was the same way, very wide threads on the section, needed an o-ring to effectively make that an eye dropper).

Link to comment
Share on other sites

It's likely that even with the silicone grease there was still getting in (my pilot petit1 was the same way, very wide threads on the section, needed an o-ring to effectively make that an eye dropper).

i will order some… Thanks! My Pilot Prera is being used as an eyedropper since i received it with no problems-no O-ring. i cannot order from Goulet because of their website problems. It doesn't run well on my iMac.

 

Where to order from?

 

 

Edited by Oldtimer
Link to comment
Share on other sites

Ebay for O-rings. The Penmanship works just fine as an eyedropper with silicone grease: no need for O-rings, in my experience.

Edited by brunico
Link to comment
Share on other sites

Ebay for O-rings. The Penmanship works just fine as an eyedropper with silicone grease: no need for O-rings, in my experience.

Unless of course some of them don't have perfectly identical threading, or not enough grease, or there's a crack/hole/etc somewhere.

Link to comment
Share on other sites

Added lots of silicon, still is dropping ink from the feeder (below nib) and from the tines ( blob of ink on top). Now i have two with the same problem

Link to comment
Share on other sites

Eyedropper filled pens are just asking for trouble in my experience. I know plenty of people love them but every single time I've tried it, I've had ink blobs and leakage, even with o-rings and grease

Link to comment
Share on other sites

I will be filling ink cartridges forever, i guess..it's a bad surprise when it happens. You never know when they are coming out. As i said before, i think- have a Prera as eyedropper,no o-ring and works perfectly fine. it's something with the Penmanship. Thanks anyway. I was going to order the o-rings but i think not now.

Link to comment
Share on other sites

Eyedropper filled pens are just asking for trouble in my experience. I know plenty of people love them but every single time I've tried it, I've had ink blobs and leakage, even with o-rings and grease

Could also be some inks are just not ED friendly. Plus it's not like the pens were designed to be EDs, they were just suitable for conversion most of the time.

Link to comment
Share on other sites

Could also be some inks are just not ED friendly. Plus it's not like the pens were designed to be EDs, they were just suitable for conversion most of the time.

Last occurrence: i had one with cartridge and the other as eyedropper. I Used the eyedropper The whole day and at the end of the day i went to use the ONE WITH THE CARTRIDGE. Sorry. Anyway, the cap was full of ink! It had leaked heavily while standing cap down with the cartridge.

 

I know it is a cheap pen, and i shouldn't expect perfection, but even cheaper ones work perfectly. Just a cautionary note for any future users so they don't place them down in their pockets. I either received two bad pens or something else is going on. The one used as eyedropper is full of Noodler's Black. It also leaked into the cap as it laid cap down in a pen holder.

 

Both of them came with converters and that is the only mode i have still to try.

Edited by Oldtimer
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Most Contributions

    1. amberleadavis
      amberleadavis
      43844
    2. PAKMAN
      PAKMAN
      33582
    3. Ghost Plane
      Ghost Plane
      28220
    4. inkstainedruth
      inkstainedruth
      26771
    5. jar
      jar
      26105
  • Upcoming Events

  • Blog Comments

    • Shanghai Knife Dude
      I have the Sailor Naginata and some fancy blade nibs coming after 2022 by a number of new workshop from China.  With all my respect, IMHO, they are all (bleep) in doing chinese characters.  Go use a bush, or at least a bush pen. 
    • A Smug Dill
      It is the reason why I'm so keen on the idea of a personal library — of pens, nibs, inks, paper products, etc. — and spent so much money, as well as time and effort, to “build” it for myself (because I can't simply remember everything, especially as I'm getting older fast) and my wife, so that we can “know”; and, instead of just disposing of what displeased us, or even just not good enough to be “given the time of day” against competition from >500 other pens and >500 other inks for our at
    • adamselene
      Agreed.  And I think it’s good to be aware of this early on and think about at the point of buying rather than rationalizing a purchase..
    • A Smug Dill
      Alas, one cannot know “good” without some idea of “bad” against which to contrast; and, as one of my former bosses (back when I was in my twenties) used to say, “on the scale of good to bad…”, it's a spectrum, not a dichotomy. Whereas subjectively acceptable (or tolerable) and unacceptable may well be a dichotomy to someone, and finding whether the threshold or cusp between them lies takes experiencing many degrees of less-than-ideal, especially if the decision is somehow influenced by factors o
    • adamselene
      I got my first real fountain pen on my 60th birthday and many hundreds of pens later I’ve often thought of what I should’ve known in the beginning. I have many pens, the majority of which have some objectionable feature. If they are too delicate, or can’t be posted, or they are too precious to face losing , still they are users, but only in very limited environments..  I have a big disliking for pens that have the cap jump into the air and fly off. I object to Pens that dry out, or leave blobs o
  • Chatbox

    You don't have permission to chat.
    Load More
  • Files






×
×
  • Create New...